Description

2.0ounce

Mold Size: 6-1/2” w x 3” h x 2” d

2 ounce shot. Teflon coated ram and cylinder, power switch and GFI built in. This new design features an advanced ram speed control for repeating precise cycle parameters with consistent results. This unit is ideal for prototyping and light non-automated runs. Features include: electronic heat control, built in air oiler, mold shims, and 15,000-lb. Mold clamp.

Specifications:

Capacity – 2.0 ounce

Compatible Plastics – Use IASCO Polystyrene, Polyethylene, or Polypropylene pellets

Mold Size: 6-7/8” w x 3” h x 2” d

110VAC – 700W

Air Input – Quick Disconnect

Electronic Heat Control

Regulator – 2 lbs./click

Requires tank type compressor (not included)

Units feature:

Air Filter and Regulator

Over-Center Clamp

Electronic Heat Control

Teflon coated ram and cylinder